Full Product Manual

PATHWAY

3G Modular Access System Assembly Manual Page 43 of 77

4.6.12.

Insert adjustable elbows into the open ramp handrail, the Bolt-On Stub Rail, and the open ends

of the welded handrail extension (FIG. 4.17).

4.6.13.

Align the adjustable elbows and measure and trim the 1-1/2” diameter handrail tubes

connecting the ramp handrail and Bolt-On Stub Rail to the handrail extension. Measure both

upper and lower gaps because they could be different and trim tubes accordingly. The

procedure for installing the 1-1/2” diameter handrail tubes and adjustable elbows is the same

as installing the closure top rail (refer to ‘CLOSURES’).

4.6.14.

FIG. 4.17 shows the completed connection.

4.6.15.

Ensure all fasteners on both sides are tightened securely.

FIG. 4.17

4.6.16.

After installing ramp handrails, insert the Short Side Vertical Picket on the “short” side of the

45-degree Angle Platform. Align the bottom of the posts with the bottom of the corner

pockets and tighten the set screws securely. Install angle caps on top of each post (FIG. 4.18).

Refer to SECTION 4.4 for installing platform handrails and attaching angle caps.

4.6.17.

Insert adjustable elbows into both ramp handrails and install 1-1/2” diameter handrail

tubes in the same manner as described in ‘HANDRAILS’ and shown in FIG. 4.19.