User manual

11
 Play File：
：：
：Touch the button area to play the corresponding file.
 Button Functions：
：：
：There are three buttons below on the screen while broadcasting files.
 HOME：
：：
：Touch this button to back and play the default file (layer 1).
 PREV：
：：
：Touch this button to get back to the previous layer.
 REPLAY：
：：
：Touch this button to replay the file.
8.1.3 Screen Calibration
NOTE：
：：
：The device has already been calibrated from the factory. Calibration only needed to be
performed if the screen inaccuracy is noticed.
Step 1：
：：
：Press the “EDIT” button on remote control to open the “CALIBRATION” window.
Step 2：
：：
：There are five calibration points
displayed, touch (click) and hold on the
center of calibration point “1” or the corner
of the display area (calibration points “2〜5”)
until the next calibration point changes the
color from blue to yellow.
Step 3：
：：
：Finish the calibration steps from
point “1〜5” twice, then the
“CALIBRATION OK” will appear on the
screen. The calibration window will now exit.
12
8.2 ADVANCE TYPE (version: theater)
8.2.1 Tree Diagram
 The advance type supports 4 layers.
 Create Files on a PC
Step 1：
：：
：Create a default file which show the 1 division button (layer 1), and name the file
“01_xxx.xxx”.
Step 2：
：：
：Create a demo file which show the 10 division buttons (layer 2), and name the file
“02_xxx.xxx”.
Step 3：
：：
：Create 4 demo files which show the 10 division buttons (layer 3), and name the files
“03_xxx.xxx 〜 06_xxx.xxx”.
Step 4：
：：
：Create 16 demo files which show the 7 division buttons (layer 4), and name the files
“07_xxx.xxx 〜 22_xxx.xxx”
Step 5：
：：
：Copy all the files (22 files) on the memory card.
8.2.2 Play a File on the Touch Screen
Make sure the “TOUCH PANEL” function is enabled first.
“SLIDESHOW SETUP” → “AUTO START” → “TOUCH PANEL”