Instruction manual

7. SETTING UP

 In the main menu, using the “▼” button on remote control to select the “SETUP” item, and then

press the “ENTER” button. You will be presented with the Eyezone B1080PX-4 settings screen.

 You can also press the “SETUP” button on remote control to directly open the settings screen.

(If there is file that is being play, please stop first.)

 There are five groups of sub-menu in the main menu (“Network Setup”, “FTP Setup”, “Video

Setup”, “Other Setup” and “Scrolling Setup”).

 In the settings screen, you can use the “▲、▼、

▲

、

▼

” buttons to select an item, and press the

“ENTER” button to confirm the selection.

 Press the “SETUP” button on remote control to save and quit the settings screen.

7.1 NETWORK SETUP

7.1.1 Setting the Network from the OSD Menu

 Network with: Select your network connection Disable/ RJ45.

 IP Assigned by DHCP: If you have a DHCP-enabled router, please select “On”, and then the

router will automatically assigns an IP address to the Eyezone B1080PX-4. If you don’t have a

DHCP –enabled router, select “Off” and type the network information in “Assign IP Address”.

7.1 NETWORK SETUP (continued)

 Assign IP Address: If the Eyezone B1080PX-4 is connected to a network without a DHCP

server or you want to use Local FTP Server function, enter the fixed IP address, Mask, Gateway

and DNS for the Eyezone B1080PX-4.

PS. Refer to 5.1 for how to enter IP address by remote control.

NOTE: Before setting the IP address, Mask, Gateway and DNS, check the network information

of your PC. Please follow the steps below to get the network information of your PC.

Step 1: Click on “Start” → “Run” and type in “command”, then press “ENTER”.

The MS-DOS window will appear, type in “ipconfig” and then press “ENTER” to get the network

information.

Step 2: Assign IP Address, Mask (Subnet Mask) and Gateway (Default Gateway) for the

Eyezone B1080PX-4.

Enter the same values of the Subnet Mask and Gateway, and be careful not to enter the values

of IP address that are already used by other devices on the network.