Installation & Assembly

Asdfdsaasldjkfh’nlkajsdf
*NoMO can be installed on either side of the toilet. To switch sides, twist and
remove the filter-housing lid (3.), turn 180
o
, ensuring the power button is facing forward,
the re-attach. After this step is complete, remove the inlet cap from the side of the inlet
and place on the opposite side.
Charging NoMO
To charge NoMO, you can charge in place, or you can remove the Battery pack/Control
Module or entire unit and plug the battery Charger into the inlet at the bottom. Charge
time = 2hrs. Charge lasts 2-4 months of normal use.
Operation and Modes
i. To power up to Manual Mode, touch Power Button, green LED stays
illuminated during 2 min power cycle, no LED outside power cycle.
ii. In Manual mode, when power is 15-5%, red LED stays illuminated during 2
min power cycle and then red LED blinks every 5 seconds.
iii. To activate Touch-less mode, from Manual mode, hold Power Button for 2
seconds (green LED will illuminate during 2 min power cycle and single green
LED blinks every 5 seconds outside power cycle.
iv. In Touch-less mode, when battery is 15%-5% charged, unit goes to Manual
mode with double red blink every 5 seconds and red LED stays illuminated
during 2 min power cycle.
v. To Power Off, hold Power Button for 5 seconds to Power Off.
vi. When battery is less than 5%, unit Powers Off.