User guide

N O T E
The Recode tab is not accessible if Symbol Mode is set to OFF.
3
Traces
This tab provides the following options:
– Copy
Choose this option to copy data from one trace to another.
– Swap Traces
Choose this option to swap data between the traces.
N O T E
The Copy and Swap features are enabled only when there are two traces (Pattern
A and Pattern B when alternate pattern is used for single channel or Data and Aux
Data pattern for second channel). For normal pattern or when PG is in multiplexer
mode, Copy and Trace will be disabled as there will be only one pattern/trace
available.
– Reverse Traces
Choose this option to reverses the data in the selected range.
4
Rotate
This tab provides the following options:
– Rotate Left
Treats the pattern data in the specified range as a circular buffer and rotates
the bits to the left by the specified amount. No data will be lost and what
is at the start of the buffer will be at the end of the buffer after the rotation.
3 Setting up Patterns
88 Agilent J-BERT N4903B High-Performance Serial BERT