User guide

Removing a Printer
When you disconnect a printer from the instrument and no longer intend to use it,
you can remove the printer driver and increase the free disk space available on the
instrument's internal hard disk drive.
To remove a printer driver:
1
On the File menu, click Print Setup, then Configure Printer.... This opens the
Printers dialog box.
2
Click the printer driver you want to remove.
3
In the File menu in the Printers dialog box, select Delete. A dialog box will
appear to confirm the removal of the printer driver.
4
Click Yes to confirm your selection.
Setting the Default Printer
You can set the printer you use most often as the default printer. Then all printouts
will be sent to the default printer unless you explicitly select another printer.
To specify the default printer:
1
On the File menu, click Print Setup, then Configure Printer.... This opens the
Printers dialog box.
2
Choose one of the currently mapped printers. If the printer you want to use is
not yet included in this list, see “Adding a Printer” on page 555.
3
On the File menu in the Printers dialog box, click Set As Default.
4
Click Close. The default printer selection is applied and the dialog box closes.
N O T E
The printer capabilities will vary depending on the printer you have installed and
configured.
Printing a Hardcopy
N O T E
Before you can print, you must first have the appropriate printer driver installed. The
printer properties and capabilities will vary depending on the printer you have
installed and configured for the instrument.
To print a hardcopy of the instrument's display to the default printer:
• Click Print from the File menu on the main menu bar.
10 Customizing the Instrument
556 Agilent J-BERT N4903B High-Performance Serial BERT