User guide

Printing
Printing - Procedures
This section provides information on setting up and using a printer:
Connecting a Printer to the Instrument
The instrument supports parallel and serial printers as well as USB and LAN
connected printers.
To connect your printer to the instrument:
1
Turn off power to the instrument and printer before connecting.
2
Connect the printer to the instrument with the cable that came with your printer.
Once you have connected the printer to the instrument, you will need to add the
printer driver before you can use the printer.
Adding a Printer
Use the following procedure to add a printer to the instrument.
1
On the File menu, click Print Setup, then Add Printer... This opens the Add
Printer Wizard dialog box.
2
Click My Computer for a local printer installation, or click Network printer
server for a printer connected to another server.
N O T E
Before you can add a network printer, you must connect to a Local Area Network
(LAN). In addition, your login must provide you with access to the network printers
that you wish to add. Please contact your network administrator or IT department
for assistance.
3
Follow the instructions in the Add Printer Wizard until you have selected a
local printer and configured the printer port.
4
If your printer is not in the list of available printers, you will need a copy of the
printer driver. Use the USB Stick to copy the printer driver into the local drive
of your system and click Have Disk button.
The instrument will then prompt you to locate the drive for printer driver. Type
the path where the printer driver is copied.
5
Follow all other instructions on the screen to finish adding a printer.
Customizing the Instrument 10
Agilent J-BERT N4903B High-Performance Serial BERT 555