User guide

2
Press the On-Screen Keyboard button to open the on-screen keyboard.
3
Click letters or numbers as desired. For numbers, you must add the unit by
pressing the G/n, k/m, M/µ, or x1 front panel button.
4
Press the On-Screen Keyboard button again to close the on-screen keyboard.
5
Continue with your work.
N O T E
You can also access the on-screen keyboard from the Utilities menu. A check mark
appears next to the menu entry, indicating that it has been selected.
Using an External Monitor
To switch between the Serial BERT's built-in display and an external monitor, do
the following:
1
Connect the external monitor with an appropriate power supply and with the
VGA connector on the Serial BERT's rear panel.
2
If the title bar of the Serial BERT user interface is not visible, select Title Bar
from the Utility menu.
3
Minimize the Serial BERT user interface window.
4
In the system tray, next to the clock in the lower right corner, right-click the
Displayicon to open the menu with the available options.
5
Select Graphics Options, then Output To, and the desired output device:
– Monitor for an external monitor
– Notebook for the built-in display
Use the same procedure to switch back to the built-in display.
Configuring the Touchscreen - Reference
This section describes the options of the on-screen keyboard:
Click Set to access the Options menu:
•
Move OSK Window
Click this to enable the arrow keys on your actual keyboard. They can then
move the software keyboard.
Customizing the Instrument 10
Agilent J-BERT N4903B High-Performance Serial BERT 533