User guide

Controlling N4876A Multiplexer
After the multiplxer function has been enabled through the Config window, the
following parameter are visible in Multiplexer (N4876A) window.
1
Provide f/2 Jitter between -10 ps to 10 ps.
For more information, refer to the section “f / 2 Jitter” on page 55
Controlling M8061A Multiplexer with De-emphasis
After the Mux with De-emphasis function has been enabled through the Config
window, the M8061A window appears as shown in the following figure.
The M8061A window contains the following tabs:
1
DataOut Tab - provides parameters to set the Amplifier, Deemphasis and
Interference. For more information, refer to the section “DataOut Tab” on page
56.
2
ClkGen Tab - provides parameters to select clock source. For more information,
refer to the section “ClkGen Tab” on page 58.
3
Electrical Idle In Tab - provides parameters to set electrical idle in. For more
information, refer to the section “Electrical Idle In” on page 58.
Setting up External Instrument(s) - Reference
Config Window
The Config window provides an inferface which allows you to enable the
functionality of the external instruments connected to the Serial BERT.
Setting up External Instrument(s) 2
Agilent J-BERT N4903B High-Performance Serial BERT 51