User guide

If you have enabled sinusoidal interference, enter appropriate values for
Frequency, Amplitude, and Mode.
Interference Channel Setup - Reference
The Interference Channel module must be enabled before it can be used. This is
done by clicking the corresponding button.
When the Interference Channel is disabled, it establishes an almost direct
connection between P1 and P2. For details about the minimum trace length refer
to the technical specifications.
Trace Number
To specify the degree of intersymbol interference, select a suitable trace length.
The user interface provides numbers from 1 to 9. The greater the number, the longer
is the trace.
Sinusoidal Interference
To enable the addition of sinusoidal interference, press the corresponding button.
Set the parameters to desired values:
The peak-to-peak amplitude of sinusoidal interference must not exceed a certain
level (see the technical specifications).
8 Jitter Tolerance Tests
432 Agilent J-BERT N4903B High-Performance Serial BERT
Amplitude