User guide

Diagram 5. Connections for a MUX/DEMUX Pair
Used to test multiplexer/demultiplexer (MUX/DEMUX) pairs. For accurate
measurement results, the timing of data signals between the MUX/DEMUX pair
must be set properly.
Diagram 6. Connections for a DCA or Oscilloscope (PGonly)
Used for measuring the output waveform of your device. For the least amount of
jitter, the clock output signal may be used as a trigger for the oscilloscope.
1 Planning the Test
32 Agilent J-BERT N4903B High-Performance Serial BERT