Instruction manual

Install your terminal.
"Selftest OK"
appears on
screen.
The terminal takes a few seconds to warm up and complete its
power up self-tests. Then, the terminal should display ‘‘Selftest
OK.’’ If a problem occurs, go to Chapter 3.
Set up your terminal.
Overview
Use Set-Up to examine or change the terminal operating
features, such as the transmit speed, receive speed, or the
language. The Set-Up menus in this section will get you started
in operating the terminal. Only the basic Set-Up feature is
performed with this procedure. There are many more Set-Up
features in the terminal that you may wish to change.
Before changing the Set-Up features, contact your System
Manager, if necessary, for information on the terminal type,
terminal ID to host, and the communication settings.
Printer operations are suspended upon entering Set-Up and are
resumed upon exiting Set-Up.
Entering Set-up
To enter Set-Up, perform the following procedures:
On a . . . Press . . . Refer to . . .
DEC VT keyboard
F3
Figure 1–1
PC keyboard
Caps Lock Print Screen
or
Caps Lock Sys Rq
Figure 1–2
1–4 Installation and Set-Up