Instruction manual

Install your terminal.
Plug in the
power cord and
push the power
switch on.
The terminal will beep indicating that the power is on.
1
2
DSG-000323
Set the
Brightness
and Contrast
controls.
If necessary, set the brightness and contrast controls by doing
the following:
1. Set both controls to maximum by turning controls all the
way to the right ( ).
2. Adjust the Brightness control by turning the control to the
left ( ) until the background raster is not visible. This sets
the black level.
3. Adjust the Contrast control by turning the control to the
left ( ) to set the white level for comfortable viewing.
4. Repeat steps 2 and 3 as needed.
Installation and Set-Up 1–3