Installation guide

ManualsBrandsExxtra ManualsComputer equipmentExxtraSetter Exxpress 300

ScriptWorks® Technical Note – Hqn028 – HQMulDev for 4.1 Page 7 Revision 1.4, 96.09.24

made for you

. This is the recommended method. If you need to check or manually update

the registry entries for any reason then you should use REGEDT32.EXE (in

WINNT\SYSTEM32). Extreme care should be taken when using regedt32 as entering

incorrect values can damage your NT installation.

See below for details of the required keys in the registry.

For HighWater ISA and Ultre PC AT cards you will still need to adjust the entries for IRQ

etc. as described below, and activate the drivers. This can be done using the supplied

Devices control panel applet.

If the card hardware configuration is changed at any point then you must adjust the values

in the registry using the Device control panel applet. If the configuration of EISA cards is

changed then the manufacturer’s EISA configuration process must be followed again.

d) Restart Windows NT

e) At a command prompt type one of the following:

Net Start HWI

<tag>

For HighWater ISA cards

or Net Start HWE

<tag>

For HighWater EISA cards

If you wish to remove the ISA HighWater driver then the keys and values as noted in the

NT Registry section below should be deleted using REGEDT32.

6. Launch ScriptWorks.

7. Use the Device Manager from the ScriptWorks menu to configure the new device:

a) Select Device Manager from the ScriptWorks menu

b) Select the HQ

<name>

plugin.

c) Click on the New button to configure a new device

d) In the Device Manager Edit dialog:

Name Enter a descriptive name. This will appear in the Output Device pop-up

menu in the Page Setup dialog.

Type Select a Device Type to match your output recorder.

Address Card String

HighWater ISA

& Ultre Corp.

The card number used in the PortX etc. entries

in SYSTEM.INI or the configuration applet (By

default this should be 0 (zero))

EISA & PCI Leave blank

e) Click on OK to add the new device to the list.

f) Add any additional devices following steps a-e.

g) Click on OK to save the new device(s)

The device(s) will now be available in the ScriptWorks Page Setup dialog.

If you are using an Ultre Corp AT interface card model number 840 you may need to perform some additional

registry editing. See below for details.

This field would normally have been set to ‘Device’ in ScriptWorks version 4.0r2 under Windows NT.