Installation guide

ScriptWorks® Technical Note – Hqn028 – HQMulDev for 4.1 Page 6 Revision 1.4, 96.09.24
a) For Windows 3.1 add one or more of the following into the [386enh] section
device=UAT <tag> .386 for Ultre cards
device=HWI <tag> .386 for HighWater ISA cards
device=HWE <tag> .386 for HighWater EISA cards
device=PCI <tag> .386 for Harlequin PCI cards for Ultre engines
For Windows 95 add one or more of the following into the [386enh] section
device=UAT <tag> .VXD for Ultre cards
device=HWI <tag> .VXD for HighWater ISA cards
device=HWE <tag> .VXD for HighWater EISA cards
device=PCI <tag> .VXD for Harlequin PCI cards for Ultre engines
b) If running under Windows 3.1 and if using an ISA card add one or more of the
following into the [drivers] section:
HighWater=HWI
<tag> .DRV for HighWater ISA cards
Ultre=UAT <tag> .DRV for Ultre cards
No equivalent entry is required for the HighWater EISA cards or Harlequin PCI
cards. No control panel applets are yet available for Windows 95.
c) If necessary add one or more new sections as shown below. These entries are not
required for PCI or EISA cards
4
.
Port, IRQ and memory addresses must match those set on the interface card
hardware. If you have multiple interface cards of a single type installed you should
have a second set of entries under the heading labeled Port1= etc., as well as those
for card 0 as shown here. Entries may be included for up to three interface cards of
a specific type, numbered 0, 1 and 2.
[hwi
<tag> ] for HighWater ISA cards
Port0=200h
IRQ0=3h
Mem0=C000h
[uat
<tag> ] for Ultre cards
Port0=100h
IRQ0=3h
Once installed under Windows 3.1 the values of entries for HighWater ISA and
Ultre cards may be adjusted through the Drivers control panel applet. ISA card
configuration under Windows 95 must be performed by manually editing
SYSTEM.INI.
If you wish to remove the drivers then all of the new entries in SYSTEM.INI described
above should be deleted.
d) Restart Windows.
Windows NT:
If you have used the ScriptWorks installer and selected ‘Update System Files’ in the
installer Setup dialog then all appropriate additions to the registry will already have been
4
Plugins for EISA cards supplied with versions of ScriptWorks before 4.1 revision 0 required an IRQ entry. This is
no longer needed.