User Guide

2
SW USB Pro Series • Setup Guide (Continued)
Rear Panel Features and Connections
AAA
SW2 USB PRO
POWER
1.6A MAX
12V
HOSTS DEVICES REMOTE
SS 10G SS 10G USB HID
2
900 mA
100 mA
USB-C
1
1.5A
USB-C
1
USB-C
2
3
4
RS-232
Tx Rx G
R
LAN
DDD
BBB
EEE
FFF
GGG
HHH
III
Figure 2. Rear Panel — SW2 USB Pro
SW4 USB PRO
POWER
1.6A MAX
12V
HOSTS DEVICES REMOTE
SS 10G SS 10G USB HID
2
900 mA
100 mA
USB-C
1
1.5A
USB-C
1
USB-C
2
3
4
RS-232
Tx Rx G
R
LAN
34
AAA
DDD
BBB
EEE
FFF
GGG
HHH
III
CCC
Figure 3. Rear Panel — SW4 USB Pro
A
2-pole DC Power connector
F
Outputs 3 and 4 — USB Type A connectors
for USB 2.0 and 1.x
B
USB-C host connectors
C
USB Type B host connectors (SW4 USB Pro only)
G
Remote RS-232 port
D
Device 1 — USB-C connector for USB 3.2, 2.0, and 1.x
H
LAN (Ethernet) connector
E
Device 2 — USB Type A connector for USB 3.2, 2.0, and 1.x
I
Reset (R) button and LED
Installation Steps
1. (Optional) Mount the switcher to a rack shelf or furniture.
2. Connect host PCs to the SW USB Pro USB‑C input connectors (see gure 2 or 3,
B
). The USB‑C host connectors do not
provide power to the connected host PCs.
3. Connect one or more peripheral USB devices (for example, keyboards, mice, or USB cameras) to the SW USB Pro output
device ports (
D
through
F
).
If host emulation will be used, attach a standard keyboard or mouse to USB host port 3 or 4 (
C
). If host emulation is not
used, connect devices to any desired port.
4. (Optional) Connect an RS‑232 cable between the SW USB Pro RS‑232 port (
G
) and a host computer or control system, or
connect the SW USB Pro Ethernet port (
H
) to the network via a standard Ethernet cable (see the SW USB Pro Series User
Guide, available at www.extron.com).
Default LAN settings:
• Rear panel LAN IP address — 192.168.254.254
• Front Panel USB-C port IP address — 203.0.113.22 at port 22023
• Subnet mask: 255.255.255.0
• Gateway: 0.0.0.0
• DNS: 0.0.0.0
• Username: admin
• Password: The product unit serial number. If an absolute system reset is performed, all passwords on this device are
reset to extron.
NOTES:
• The computer used for RS‑232 control should not be one of the host devices connected to any of the input ports.
• The LAN IP address can be changed, however, the USB‑C port IP address is fixed at 203.0.113.22 and cannot be
changed.