User`s manual

YCS 100 • Installation and Operation
Installation and Operation, cont’d
2-12
YCS 100 • Installation and Operation
2-13
7
Power connector — Plug the external 12 VDC power supply
into this 2-pin, 3.5 mm captive screw connector.
Wiring the Power Connector
To wire the connector for the external power supply,
1. Cut the DC output cord to the length needed.
2. Strip the jacket to expose 0.2 inches (5 mm) of the
conductors.
C
Exposing more than 0.2" (5 mm) of the copper
wires could allow the stripped wires to touch each
other, causing a short circuit. This could result in
the external DC power supply overheating and/or
burning.
Stripping the wires to expose less than the
recommended amount may cause them to slide out
of the connector too easily, even if they are tightly
pinched by the captive screws.
3. Slide the leads into the supplied 2-pin captive screw plug
and secure them, using an Extron Tweeker or other small
screwdriver.
4. Use the supplied tie wrap to strap the power cord to the
extended tail of the connector.
5. To verify the power cord’s polarity before connecting
it, plug in the power supply with no load and check the
output with a voltmeter.
Figure 2-12 shows how to wire the connector.
Power Supply
Output Cord
Orange Captive Screw
Connector
0.2” (5 mm) MAX
SECTION A–A
Ridges
Smooth
AA
Tie Wrap
Figure 2-12 — Power connector wiring
10. Secure the L-shaped bracket to the square U-bolt using the
included hex nuts, washers, and lock washers. Tighten the
hex nuts securely.
N
Be sure to tighten the hex nuts securely enough that the
PMK 350 does not slide down the ceiling pole. A socket
wrench is recommended to tighten the hex nuts.
11. Secure the front panel to the mounting tray with four of
the included #6 screws.
12. If desired, choose one of the provided four sizes of self-
adhesive cover sheets, and apply it to the underside of the
mounting tray.
Rear Panel
DECODER
LOOP LOOPOUTOUT
ENCODER
YCS 100
IN IN
12V
0.3A MAX
6
1
2
35
7
4
Figure 2-11 — YCS 100 rear panel
The YCS 100 rear panel contains the following features:
1
Input composite video connector (decoder) — Connect a
composite video input source to this BNC connector.
2
Input S-video connector (encoder) — Connect an S-video input
source to this 4-pin mini-DIN connector.
3
S-video loop-through connector (encoder) — Connect a
monitor or other deviceto this 4-pin mini-DIN loop-through
connector.
4
Composite video output connector (encoder) — Connect a
composite video display device to this BNC connector.
5
S-video output connector (decoder) — Connect an S-video
display device to this female 4-pin mini-DIN connector.
6
Composite video loop-through connector (decoder) — Connect
a monitor or other device to this BNC loop-through connector.