User guide

XTP T VGA Transmitter • Reference Information 31
Installing Firmware with Firmware Loader
Use the Firmware Loader utility to upload firmware to the transmitter when connected
directly to the device.
1. Connect the host device to the front panel USB port.
2. Open Firmware Loader and establish a connection between the computer and the
device. The Add Device... dialog box opens.
Figure 32. Add Device... Dialog Box
3. From the Device Name drop-down list, select XTP T VGA.
4. From the Connection Method drop-down list, select the method of connection.
5. Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
6. Click the Connect button.
7. In the New File Firmware (Optional) panel, click the Browse button.
8. In the Open dialog box, navigate to the location of the new firmware file, select the
desired file.
ATTENTION: Valid firmware files must have the file extension .S19. A file with any
other extension is not a firmware upgrade for this device and could cause the
device to stop functioning.
9. Click the Open button. The Browse dialog box closes.
10. Click the Add button. The Add Device... dialog box closes and the device and firmware
are listed in the Firmware Loader main window.
11. Click the Begin button to start the upload process.
12. Close Firmware Loader when the Remaining Time field shows 00.00.00, the
Progress column shows 100%, and the Status field shows completed