User guide

XTP T VGA Transmitter • XTP System Configuration Software 24
Audio tab
Click the Audio tab (see figure 26,
1
) to open the Audio screen. It contains input gain and
output video mute options.
Figure 26. Audio Tab
Input panel
The analog input gain fader has a gain range of -18 to +24 dB. Adjustments are applied in
1 dB increments. The default setting is 0 dB.
2
Input Gain — Click and drag the handle of the Gain slider, enter a value in the field, or
click the Up or Down arrow to adjust the analog input gain.
Output panel
The transmitter uses a black signal to simulate a 720p or 1080p, 50 Hz or 60 Hz signal so
audio can be passed without video.
3
Allow Audio Only — To allow audio only to be output, select the Allow Audio Only
check box. When enabled, select the desired resolution and refresh rate from the
Signal Type drop-down list to emulate in place of video.
Factory reset
Click the Factory Reset button (see figure 19,
2
on page 21) to reset the transmitter to
factory settings except for firmware.