User guide

XTP T VGA Transmitter • XTP System Configuration Software 22
Input Configuration panel
2
Signal Type — From the Signal Type drop-down list, click the desired signal type.
3
Auto-Image — Attempts to size and center the input signal based on the aspect ratio
setting. Auto-Image is applied whenever there is a change in the input sync.
4
Auto Memory — Recalls input and image settings for signals that have previously been
applied. When it is disabled, the XTP T VGA treats every newly applied input as a new
source.
Image Settings panel
5
Signal Sampling — To adjust signal sampling settings, enter a value within acceptable
range (displayed in parentheses to the right of the corresponding field) in the desired field
or click the Up and Down arrows.
Figure 21. Signal Sampling Settings
6
Horizontal and Vertical Shift — To adjust the horizontal and vertical shift settings,
enter a value within the Min and Max values displayed to the right of the corresponding
field or click the Up or Down arrows.
Figure 22. Shift Settings
7
Picture Control — Click and drag the associated slider for any image setting
(brightness, contrast, color, or tint).
Alternatively, enter a value within the field associated with the image setting, or click the
Up and Down arrows to change the value in the field.
Figure 23. Picture Control Settings
8
Image Reset — To reset color, tint, brightness, contrast, phase, horizontal shift, and
vertical shift settings, click the Image Reset button to set pixel phase, horizontal shift,
and vertical to the default values.