User guide

XTP T VGA Transmitter • SIS Configuration and Control 15
Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
Horizontal shift
Set horizontal shift
EX( HCTR} HctrX(]
Set the horizontal location of the first
active pixel.
Increment value
E+HCTR} HctrX(]
Move the image to the right.
Decrement value
E-HCTR} HctrX(]
Move the image to the left.
View horizontal shift
EHCTR} HctrX(]
Show the horizontal location of the
first active pixel.
Vertical shift
Set vertical shift
EX( VCTR} VctrX(]
Set the vertical location of the first
active pixel.
Increment value
E+VCTR} VctrX(]
Move the image down.
Decrement value
E-VCTR} VctrX(]
Move the image up.
View vertical shift
EVCTR} VctrX(]
Show vertical location of the first
active pixel.
Image reset
Execute an image reset
1A
Aadj1
]
Set picture adjustment settings to
the default values.
Preset Commands
Save an input preset
X1), SprX1)]
Save the current configuration to
preset X1).
Recall an input preset
X1). RprX1)] Recall the preset X1) configuration.
EDID Commands
NOTE: For EDID management, use the XTP System Configuration Software (see EDID Minder on page 26).
Advanced Configuration Commands
Test pattern
Set a test pattern
X1@J TstX1@]
Set a test pattern or disable one.
View the current test
pattern
J
Tst
X1@]
View the current test pattern.
Factory defaults
System reset
EZXXX} Zpx]
Resets unit to factory default.
Status
View input signal presence
0LS
FrqX1$]
View the presence of an input signal.
Query firmware version
Q
x.xx]
View the firmware version.
Query full firmware version
*Q
x.xx.xxxx]
View the full firmware version.
Query part number
N
60-1231-12]
View the part number.
NOTE: X( = Horizontal or vertical shift 0-65535 (32768 = default)
X1) = Preset number 1-8
X1@ = Test pattern 0 = off (default)
1 = 720p @ 50 Hz
3 = 720p @ 60 Hz
5 = 1080p @ 60 Hz
X1$ = Input signal presence 0 = no input detected
1 = input detected