User guide

XTP T VGA Transmitter • Installation and Operation 10
Operation
Front Panel Features
INPUT
S-VIDEO
VIDEO
RGB
YUV
AUDIO SIGNAL CLIP
XTP T VGA
CONFIG
AB C
Figure 9. XTP T VGA Front Panel Features
A
Power LED indicator — Lights when power is applied to the unit. There are two
Power LED indicators, one on the front panel and one on the left side of the rear panel.
B
Config port — Connect a host device to the front panel mini USB B Config port.
C
LED indicators:
Video LED indicator — Lights when a composite video signal is detected.
S-video LED indicator — Lights when an S-video signal is detected.
YUV LED indicator — Lights when a component video signal is detected.
RGB LED indicator —Lights when an RGB video signal is detected.
Audio Signal Clip LED indicator — Lights when the analog audio input signal is
-3 dBFS or above. The light remains lit for 200 ms after the audio input signal drops
below -3 dBFS.
EDID
To manage EDID on the XTP T VGA, use the XTP System Configuration Software (see EDID
Minder on page 26). The XTP T VGA can record and save EDID in a user memory location,
select a pre-defined EDID, or use EDID from a display connected to a receiver. EDID stored
in the user memory location can come from the display connected to a receiver or a custom
EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the transmitter is assigned by the matrix
switcher using the XTP System Configuration Software.
Reset Modes
Use the recessed Reset button on the rear panel of the switcher to return the device to
default settings or to restore factory-shipped firmware.
Reset Mode Summary
Mode Activation Result Purpose/Notes
Factory Reset
(Mode 1)
Press the recessed Reset button
while applying power to the device.
NOTE: After a mode 1 reset,
update the device with the
latest firmware version. DO
NOT operate the system
with the firmware version that
results from this mode reset.
The device reverts to the factory
default firmware.
NOTE: If you do not want to
update the firmware or if you
perform a mode 1 reset by
mistake, cycle power to the
device to return the firmware
version running prior to the reset.
Use mode 1 to roll back
to factory firmware for a
single power cycle if an
incompatibility issue arises.
RESET