User guide

Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
EDID
Assign factory EDID
EAX!*X2$EDID} EdidAX!*X2$]
Set the EDID resolution and
refresh for input X!.
View assigned EDID
EAX!EDID} EdidAX!*X2$]
View EDID resolution and
refresh for input X!.
Advanced Configuration
Executive mode
Set executive mode
X$X ExeX$]
Lock or unlock the front panel.
View executive mode status
X
Exe
X$]
View the executive mode
status.
HDCP authorized device (HDMI inputs only)
HDCP authorized device On
EE1HDCP} HdcpE1]
HDCP authorized device on
(default).
HDCP authorized device Off
EE0HDCP} HdcpE0]
HDCP authorized device off.
Query HDCP authorized
device status
EEHDCP} HdcpEX2)]
View the HDCP authorized
device status.
Test pattern
Set a test pattern
X1)J TstX1)]
Set a test pattern or disable
one.
View the current test pattern
J
Tst
X1)]
View the current test pattern.
Status
View input signal presence
0LS
Frq
X2@X2@X2@]
View the input signal presence
of each input.
Query HDCP input
EIHDCP} HdcpI0X2!X2!]
View the HDCP input status of
inputs 2 and 3.
Query firmware version
Q
x.xx
]
View the firmware version.
Query full firmware version
*Q
x.xx.xxxx]
View the full firmware version.
Query part number
N 60-1198-01
View the device part number.
Factory defaults
System Reset
EZXXX} Zpx]
Resets unit to factory default.
NOTE: X! = Input selection 1 = VGA (input 1)
2 = HDMI (input 2)
3 = HDMI (input 3)
X$ = Enable or disable 0 = disable (default for executive mode)
1 = enable
X1) = Color bar test pattern 0 = disable (default)
1 = 720p @ 50 Hz
3 = 720p @ 60 Hz
5 = 1080p @ 60 Hz
X2) = HDCP Authorization 0 = HDCP authorization off
1 = HDCP authorization on (default)
X2! = HDCP status 0 = no source or output connected
1 = HDCP compliant source
2 = non-HDCP compliant source
X2@ = Video signal status 0 = video or TMDS not detected
1 = video or TMDS detected
X2$ = EDID communication output resolution See the EDID Emulation Table on page 14.
XTP T USW 103 • SIS Configuration and Control 17