User guide

Selecting an Input
To select an input from the front panel, perform the following actions:
Press the input selection button that corresponds with the desired rear panel input
connector. The corresponding LED lights to indicate the active input.
Setting the Front Panel Lockout Mode (Executive Mode)
Push and hold (for about 5 seconds) inputs 1, 2, and 3 simultaneously until all front panel
LEDs blink three times to enable or disable front panel configuration.
In executive mode, input selection and mode switches from the front panel are disabled, but
RS-232 control and contact closure are still available.
Enabling Auto Switch Mode
Press and hold (for about 3 seconds) inputs 1 and 3 simultaneously until the Auto Switch
LED lights. In auto switch mode, the switcher automatically switches to the highest
numbered input with an active video signal.
NOTE: Setting auto switch mode to prioritize the lowest numbered active input can be
done only with SIS commands (see Auto switch mode SIS commands on page 15).
Normal switch mode is the default switch mode.
The audio input selected depends on the audio input selection setting (see Audio input
selection SIS commands on page 15).
Enabling Normal Switch Mode
Press and hold (for about 3 seconds) inputs 1 and 2 simultaneously until the Auto Switch
LED turns off. This is the default switch mode.
EDID
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher
using the XTP System Configuration Software.
The XTP T USW 103 can record and save EDID in a user memory location on the switcher.
Connect a host device to the XTP transmitter for EDID control (see SIS Configuration and
Control on page 13 or XTP System Configuration Software on page 18).
XTP T USW 103 • Operation 11