User guide

General tab
Click the General tab (see figure 25,
1
) to open the General screen. It contains settings for
front panel lockout (executive) mode, auto switch mode, and factory reset.
Figure 25. General Tab
Executive Mode panel
2
Unlock the Front Panel — Click the Unlock Front Panel radio button (default) to
disable front panel lockout (executive) mode.
3
Lock the Front Panel — Click the Lock Front Panel radio button to enable
front panel lockout (executive) mode (see Setting the Front Panel Lockout Mode
(Executive Mode) on page 11).
Auto-input Switching panel
4
Auto-input Switching — Click the Enable Auto-Input Switching check box to
enable auto switch mode. Two settings are available for this mode.
• Click the Priority to highest active input number radio button to
automatically switch to the highest numbered active input.
• Click the Priority to lowest active input number radio button to
automatically switch to the lowest numbered active input.
Factory reset
5
Click the Factory Reset button to reset the transmitter to factory settings except for
firmware.
NOTE: This is the same as the EZXXX SIS command (see the System reset SIS
command on page 18).
XTP T USW 103 Switcher • XTP System Configuration Software 28