User guide

Input/Output tab
Click the Input/Output tab (see figure 22,
1
) to open the Input/Output screen. It contains
input information and options to apply automatic settings to individual inputs.
Figure 22. Input/Output Tab
2
Input Name— Displays the input name.
3
Signal Type — Displays the signal type of each input. Input 1 is analog. Inputs 2 and 3
are HDMI/DVI.
4
Auto-Image — Attempts to size and center the input signal based on the aspect ratio
setting. Auto-Image is applied whenever there is a change in the input sync.
5
Auto Memory — Recalls input and image settings for signals that have previously been
applied. When it is disabled, the XTP T USW 103 treats every newly applied input as a
new source.
6
HDCP Authorized — Select either HDCP Authorized check box to have the input
report as an HDCP authorized device. If the box is not checked, the source is blocked
from encrypting its output. This may result in some content not being passed by the
source device.
NOTE: HDCP authorization is for inputs 2 and 3 only.
XTP T USW 103 Switcher • XTP System Configuration Software 25