User guide

Reset Mode
Use the recessed Reset button on the rear panel of the switcher to return the device to
default settings or to restore factory-shipped firmware.
POWER
12V
2
1.0 A MAX
G
1
SIG LINK
XTP OUT
LAN
AUDIO
RGB HDMI HDMI
CONTACT
Rx GGTx
RS-232 IR
RxTx
RS-232
Tx Tx
3
123
R
OVER XTP REMOTE
INPUTS
A
Figure 11. Rear Panel Reset Button
Reset Mode Summary
Mode Activation Result Purpose/Notes
Factory Reset
Press the recessed Reset button
while applying power to the device.
NOTE: After a mode 1 reset,
update the device with the
latest firmware version. DO
NOT operate the system
with the firmware version that
results from this mode reset.
The device reverts to the factory
default firmware.
NOTE: If you do not want to
update the firmware or perform
a mode 1 reset by mistake,
cycle power to the device to
return the firmware version
running prior to the reset.
Use mode 1 to roll back
to factory firmware for a
single power cycle if an
incompatibility issue arises.
XTP T USW 103 Switcher • Operation 12