User guide

Selecting an Input
To select an input from the front panel, press the input selection button that corresponds
with the desired rear panel input connector. The corresponding LED lights to indicate the
active input.
Setting the Front Panel Lockout Mode (Executive Mode)
To enable or disable front panel lockout mode, press and hold (for about 5 seconds) input
buttons 1, 2, and 3 simultaneously until all front panel LEDs blink three times.
In front panel lockout mode, input selection from the front panel is disabled, but RS-232 and
USB control and contact closure are still available.
Enabling Auto Switch Mode
Press and hold (for about 3 seconds) inputs 1 and 3 simultaneously until the Auto Switch
LED lights. In auto switch mode, the switcher automatically switches to the highest
numbered input with an active video signal.
NOTE: Setting auto switch mode to prioritize the lowest numbered active input can be
done only with SIS commands (see Auto switch mode SIS commands on page 15).
Normal switch mode is the default switch mode.
The audio input selected depends on the audio input selection setting (see Audio input
selection SIS commands on page 15).
Enabling Normal Switch Mode
Press and hold (for about 8 seconds) inputs 1 and 2 simultaneously until the Auto Switch
LED turns off. This is the default switch mode.
EDID
To manage EDID on the XTP T USW 103, use the XTP System Configuration Software
(see EDID Minder on page 30). The XTP T USW 103 can record and save EDID in a user
memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the XTP matrix
switcher using the XTP System Configuration Software.
XTP T USW 103 Switcher • Operation 11