User guide

By default, audio input is selected automatically (see Audio input selection SIS
commands on page 15 to manually select audio inputs). When input 2 or 3 is selected
with automatic audio input selections, the switcher prioritizes embedded digital audio.
The following table shows the audio format that is sent over the XTP connection when a
specific audio format is not specified.
Selected
Video Input
HDMI Embedded
Audio Present
Analog Audio
Present
Audio Sent Over XTP
VGA N/A Yes Analog audio
VGA N/A No No audio
HDMI Yes No HDMI embedded audio
HDMI Yes Yes HDMI embedded audio
HDMI No Yes Analog audio
HDMI No No No audio
B
Analog video connector — Connect a video source to the female 15-pin HD
connector, labeled input 1. It accepts RGBHV video signals.
C
HDMI connectors — Connect a digital video source device to either or both female
HDMI connectors, labeled inputs 2 and 3. They can accept HDMI, DVI, or dual mode
DisplayPort video sources.
NOTES:
• The maximum cable length is 15 feet.
• Use Extron LockIt lacing brackets to secure HDMI connectors to the device
(see HDMI Connection on page 5).
D
XTP connector — Connect a twisted pair cable to the RJ-45 connector labeled
XTP Out and the XTP input port on another XTP device to pass all signals (see
TP Cable Termination and Recommendations on page 6). This cable carries the
following signals:
• Digital video
• Digital audio
• Bidirectional RS-232 and IR commands
• Remote power
• Ethernet communication
• System communication
Link LED indicator — Lights yellow when XTP devices are connected and
communication is established.
Signal LED indicator — Lights green when the transmitter outputs a video signal or a
test pattern.
ATTENTION:
• Do not connect this connector to a computer data or telecommunications
network.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see Remote power on
page 9).
E
LAN connector — Connect a control device or device to be controlled to this LAN
connector for 10/100 Ethernet communication through this pass-through port. LEDs on
this connector indicate link and activity status.
XTP T USW 103 Switcher • Installation 4