User guide

XTP T FB 202 Floor Box Transmitter • XTP System Configuration Software 32
General tab
Click the General tab (see figure 34,
1
) to open the general screen. It contains settings for
auto switch mode and factory reset.
Figure 34. General Tab
Auto-input Switching panel
2
Auto-input Switching — Click the Enable Auto-Input Switching check box to
enable auto switch mode. Two settings are available for this mode.
• Click the Priority to highest active input number radio button to
automatically switch to the highest numbered active input (HDMI).
• Click the Priority to lowest active input number radio button to
automatically switch to the lowest numbered active input (VGA).
Factory reset
3
Factory Reset — Click the Factory Reset button to reset the transmitter to factory
settings except for firmware.
NOTE: This is the same as the EZXXX SIS command (see the System reset
command on page 22).