User guide

XTP T FB 202 Floor Box Transmitter • Installation 16
Remote power
The XTP T FB 202 can be powered remotely through an XTP Power Injector or through an
XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
Power injector
To power the XTP T FB 202 remotely with an XTP Power Injector, power one device locally
(see Local power on page 15) and connect an XTP Power Injector to the XTP cable
run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
1.0 A MAX
SIG LINK
XTP OUT
G
REMOTE
RS-232
Rx
Tx
POWER
12V
1.0A MAX
−+
LAN
SIG LINK
XTP IN
POWER
12V
HDMI
1A MAX
Rx GTx
RS-232 IR
RxTx
−+−+
LR
1
2
OVER XTP
AUDIO
OFF
ON
S/PDIF
RESET
XTP R HDMI
RELAYS
OUTPUTS
AUDIO
XTP
PWR
XTP PWR
100-240V
50/60 Hz
---A MAX
Extron
XTP T FB 202
XTP Transmitter
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
Shielded Twisted
Pair Cable
Remote
Power
12V Local Power
Supply
Power
Figure 20. Typical Point-to-point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a STP cable with
24 AWG wire.
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power
to connected XTP devices (see the XTP matrix switcher user guide for more details). To
manage available power from the XTP matrix switcher, use the XTP System Configuration
Software.