User guide

XTP T FB 202 Floor Box Transmitter • Installation 12
Electraplan or PUK floor box
POWER
XTP T FB 202
V
GA
IN
HDMI IN
PWR
HDMI
VGA
HDCP
AU
TO
CLIP
AUDIO IN
LAN
REMOTE
RS-232
-
+
G
Rx
Tx
12V
1.0 A MAX
CONFIG
RES
ET
Tx
Rx
G
T
x
Rx
OVER XTP
RS-232
IR
XTP OUT
POWER
XT
P T
FB 202
VGA IN
HDMI IN
PWR
HDMI
VGA
HDCP
AUTO
CL
I
P
AUDIO IN
LAN
REMO
TE
RS-232
-
+
G
Rx
T
x
12V
A
MAX
CONFIG
R
ESET
Tx
Rx
G
Tx
Rx
OVER XTP
RS-232
IR
XTP OUT
Extron
XTP T FB 202
(shown in Electraplan
floorbox assembly)
995300
995300
Figure 15. Mounting the XTP T FB 202 into an Electraplan or PUK Floor Box
Connection and Wiring Details
HDMI Connection
Use an Extron LockIt Lacing Bracket to secure an HDMI cable to the HDMI connector. The
LockIt lacing bracket can be applied to the top or the side mounting screws. The following
directions describe how to attach a LockIt lacing bracket to the top mounting screw.
3
1
2
3
4
5
Figure 16. Installing the LockIt Lacing Bracket
1. Plug the HDMI cable into the panel connection (see figure 16,
1
).
2. Loosen the HDMI connection mounting screw from the panel (see
2
) enough to allow
the LockIt lacing bracket to be placed over it. The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector (see
3
),
then tighten the screw to secure the bracket.
ATTENTION: Do not overtighten the HDMI connector mounting screw. The shield
it fastens to is very thin and can easily be stripped.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket (see
4
).
5. While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length (see
5
).