User guide

XTP T FB 202 Floor Box Transmitter • Installation 10
C
LAN connector — Connect a control device or device to be controlled to this LAN
connector for 10/100 Ethernet communication through this pass-through port. LEDs on
this connector indicate link and activity status.
D
Reset button — Press and hold to reset the device (see Reset Modes on page 17).
E
Config port — Connect a host device to the front panel mini USB B configuration port.
F
LED indicators:
Power LED indicator — Lights when power is applied.
HDMI LED indicator — Lights when an HDMI input signal is detected.
VGA LED indicator — Lights when a VGA input signal is detected.
HDCP LED indicator — Lights when the HDMI input signal is encrypted.
Auto LED indicator — Lights when the device is in auto switch mode.
Clip LED indicator — Lights when the analog audio input signal remains above
-3 dBFS. It remains lit for 200 ms after the signal falls below -3 dBFS.
Mounting
Before mounting the floor box, consider the mounting location and prepare the surface as
necessary.
1. If not already completed, install the appropriate adapter plates in the desired position
and mounting slots (see Adapter Plates on page 5).
2. Align the screw holes on the XTP T FB 202 with the screw holes on the adapter plates.
3. Using the provided self-threading screws and washers, secure the XTP T FB 202 to the
adapter plates (see figures 12 though 15).
Ackermann GB3 (OBO Bettermann) floor box
POWER
XTP T FB 202
VGA IN
HDMI IN
HDMI
VGA
HDCP
AUTO
CLIP
AUDIO IN
LAN
REMOTE
RS-232
-
+
G
Rx
Tx
12V
1.0 A MAX
C
ONFIG
RESET
Tx
Rx
G
Tx
Rx
OVER XTP
RS-232
IR
XTP OUT
POWER
XTP T FB 202
VGA IN
HDMI IN
HDMI
VGA
HDCP
AUTO
CLIP
AUDIO IN
LAN
REMOTE
RS-232
-
+
G
Rx
Tx
12V
A MAX
CONFIG
RESET
Tx
Rx
G
Tx
Rx
OVER XTP
RS-232
IR
XTP OUT
Extron
XTP T FB 202
(shown in OBO Bettermann
GESR7 floorbox assembly)
995242
995241
Figure 12. Mounting the XTP T FB 202 into an Ackermann GB3 (OBO Bettermann)
Floor Box
NOTE: Position 2 requires the installation of the 995242 adapter plate over one of the
995241 adapter plate.