User guide

ManualsBrandsExtron Electronics ManualsHardwareXTP DTP 24 Plug Kit for XTP DTP 24 Cable

1. Optional: Slide a strain relief or heat shrink

over the cable. The strain relief and heat

shrink are not included.

2. Strip approximately 1.25 inches (31.8mm) of

the cable jacket from the end of the cable.

3. Remove the foil and mylar shielding (if

present) from the end of the cable.

4. Turn the cable over and atten the braid

against the bottom of the cable jacket for

grounding purposes (see note in step 11).

NOTE: In the gure at right, the cable is

viewed from beneath, so the wires are

in reverse order.

5. Separate and untwist the four exposed

twisted pair wires and trim (but do not strip)

the wires to 0.8inch (20.3 mm).

6. Arrange and lay at the eight wires in the

correct order to comply with the

TIA/EIA 568B wiring standard (see the table

at right).

NOTES: Plenum cable does not have a

stripe on the white conductor.

XTP DTP 24 Plug Kit for XTP DTP 24 Cable • Setup Guide

The Extron Shielded XTP DTP 24 RJ-45 Plug kit terminates XTP DTP 24 shielded twisted pair

cable. The plug can accommodate solid and stranded conductors with a diameter in the range

of 0.044 to 0.048inch.

The following tools are required to complete a fully shielded cable assembly:

The kit contains connectors and guides and provides a method to complete a fully shielded

cable assembly. To terminate XTP DTP 24 shielded twisted pair cable, follow these steps:

Foil Shield

Braid Shield

1.25"

Fold Back Braid

12345678

0.80"

RJ-45 Crimper

Wire Cutter/Stripper

RJ-45 Tester

Pliers

T568B Wiring

White/Blue

T568B

Wire Colors

Blue

White/Orange

Orange

White/Green

Green

White/Brown

Brown

Summary of content (2 pages)

PAGE 1
XTP DTP 24 Plug Kit for XTP DTP 24 Cable • Setup Guide The Extron Shielded XTP DTP 24 RJ-45 Plug kit terminates XTP DTP 24 shielded twisted pair cable. The plug can accommodate solid and stranded conductors with a diameter in the range of 0.044 to 0.048 inch. The following tools are required to complete a fully shielded cable assembly: RJ-45 Crimper Pliers RJ-45 Tester Wire Cutter/Stripper The kit contains connectors and guides and provides a method to complete a fully shielded cable assembly.
PAGE 2
7. Feed the individual wires, in the correct order, through the open front face of the plastic guide and out through the individual holes at the other side. The rear of the guide should be seated against the end of the jacket and braid. Heat Shrink Tubing/ Strain Relief (optional) 8. Cut the wires to 0.6 inch (15.2 mm) as shown at right. 9. Push the guide up, leaving 0.3 inch of the wires exposed above the guide (see image at right). Guide 7 8 9 0.6" 0.3" 10.