User guide

XTRA Series Power Ampliers • References 21

6. Thread the power wires through the length of the electrical conduit tube.

7. Install the EMT adapter plate with conduit attached into the opening from which the IEC

connector was removed in step 5 .

LINE

NEUTRAL

Conduit Nut

EMT Adapter Plate

Te rminal Block

Zip-Tie

Ground

Wire Nut

Hot

Te rminal (Black)

Neutral

Te rminal (White)

8. Slide the conduit nut over the bundle of wires exiting the conduit and onto the conduit

itself. Hand tighten the conduit nut to the conduit.

9. Attach the EMT adapter plate assembly to the XPA using the 2 screws removed in

step 5.

10. Connect the black hot (line) and white neutral wires to the terminal block using the

2 screws that were removed in step 3. Use the included zip tie to secure the two wires

together close to the terminals. See the following illustration.

WARNING: Ensure that you observe correct wire polarity. The following illustration

shows the location of the hot (L) and neutral (N) terminals.