User guide

XTRA Series Power Ampliers • References 20
Installing the flexible conduit kit
1. Unplug the IEC power cord from the power amplifier.
2. Remove the 8 screws from the top and sides of the XPA and lift off the cover. See the
following illustration.
CAUTION: Electrostatic discharge (ESD) can damage IC chips even though you
cannot feel it. You must be electrically grounded before touching
anything inside the XPA. A grounding wrist strap is recommended.
100-240V 0.5A, 50-60Hz
STANDBY
CLASS 2 WIRING
1
2
XPA 1002
LEVEL
1
1
2
2
INPUTS
OUTPUT
REMOTE
0
0
VOL/MUTE
10V 50 mA
1 2
LIMITER/
PROTECT
SIGNAL
AUDI O/VID EO
APPARATUS
17T T
Remove (8)
screws
Lift Cover Straight Up
3. Remove the 2 screws holding the hot (line) and neutral wires from the terminal block
on the PCB.
100-240V 1.3A
50-60Hz
Remove screws
(both sides) to release
IEC connector plate.
Remove nut
Blue Wire
Brown Wire
L
N
IEC connector.
c
d
e
4. Remove the ground wire nut from the grounding stud on the bottom of the enclosure,
as shown above.
5. Remove the 2 screws from the IEC plate, and remove the IEC connector plate and the
attached wires through the rear panel of the XPA, as shown above.