User guide
To wire the stereo output connector:
1. Strip and insert the speaker wires into the connector and tighten the captive screws.
Be sure to observe the correct polarity.
Do not tin the wires!
2. Insert the wired connector into the amplifier output and secure the locking screws
on either side.
1 2
OUTPUT
ç
Mono audio output connector — Marked “+” and “–”, wire the included 2-pole,
5 mm screw lock captive screw connector for mono audio. See the steps starting below.
The output is designed to power 70 V (XPA 2001-70V) or 100 V (XPA 2001-100V) line
distribution systems and is rated at 100 watts.
NOTE: You must use Class 2 wiring for this output to comply with UL
requirements.
XPA 2001-70V
OUTPUT
70V
XPA 2001-100V
OUTPUT
100V
WARNING: Do not short out the “+” and “–” connectors together. Doing so will
damage the amplifier.
To wire the mono output connector:
1. Strip and insert the speaker wires into the connector and tighten the captive screws.
Be certain to observe the correct polarity.
Do not tin the wires!
XTRA Series Power Ampliers • Installation and Operation 10