User guide
à
Balanced or unbalanced stereo audio input connector — Wire the 3.5 mm 5-pin
captive screw connector for balanced or unbalanced input.
Unbalanced Stereo Input
Balanced Stereo Input
Do not tin the wires!
Tip
Ring
Tip
Ring
LR
Sleeves
Tip
Sleeve
Sleeve
Tip
LR
NOTE: The XPA 1002 output power can be effectively doubled by using only
one input channel and bridging the output. The XPA 1002 will output
200 watts @ 8 ohms or 120 watts @ 16 ohms in bridged mode.
See “Bridged Mono Output” on page 12 for wiring instructions when
bridging the XPA 1002.
â
Balanced or unbalanced mono audio input connector — Wire the 3.5 mm 5-pin
captive screw connector for balanced or unbalanced input.
Do not tin the wires!
Balanced Mono Input
(high impedance)
Tip
Ring
LR
Sleeve
Unbalanced Mono Input
Tip
Sleeve
LR
NOTE: For mono input on the XPA 2001, only the left channel needs to be wired.
No jumpering to the right channel is needed.
XTRA Series Power Ampliers • Installation and Operation 8