User`s manual

XTRA Series • Operation

3-9

Step 1: Strip and insert the speaker wires into the

connector and tighten the captive screws. Be sure

to observe the correct polarity.

Do not tin the wires!

Step 2: Insert the wired connector into the ampliﬁer output and

secure the locking screws on either side.

1 2

OUTPUT

Mono audio output connector — Marked "+" and "-", wire the

included 2-pole, 5 mm screw lock captive screw connector for

mono audio. See the following steps on the next page. Output

is designed to power 70 V (XPA 2001-70V) or 100 V (XPA 2001-

100V) line distribution systems and is rated at 100 watts.

You must use Class 2 wiring for this output to comply

with UL requirements.

XPA 2001-70V

OUTPUT

70V

XPA 2001-100V

OUTPUT

100V

Do not short out the "+" and "-" connectors with

each other; doing so will damage the ampliﬁer.