User`s manual
XTRA Series • Installation
2-7
The kit provides a convenient means to replace the XPA's IEC
power cord with conduit, where required by local codes.
C
Make sure that the source device and the XPA are
turned off and disconnected from the power source
before you begin.
UL requirements
The Underwriters Laboratories (UL) requirements listed below
pertain to the installation of the exible conduit onto a XPA 1002
or XPA 2001.
• This unit is not to be used beyond its rated voltage range.
• This unit must be wired to a UL listed distribution box.
N
The UL approved electrical distribution box is not included
with either the XPA or the Flexible Conduit Adapter Kit;
the installer is responsible for obtaining and installing the
box.
Installing the exible conduit kit
Install exible conduit to the XPA by following the steps below.
1. Unplug the IEC power cord from the power amplier.
2. Remove the 8 screws from the top and sides of the XPA
and lift off the cover. See the following illustration.
C
Electrostatic discharge (ESD) can damage IC chips
even though you cannot feel it. You must be
electrically grounded before touching anything inside
the XPA. A grounding wrist strap is recommended.