Quick Start Owner's manual
WPB 103 B and WPB 107B • Quick Start
C
Installation and service must be performed by authorized
personnel only. These units must be installed in
accordance with the National Electrical Code and with
local electrical codes.
N These wall plates use pass-through connectors as well as active
audio buffering without signal processing.
To install the WPB wall plates, follow these steps.
Step 1
Select the site and run cables through the wall or furniture where
the wall plate(s) will be installed.
Step 2
Prepare the site.
a) Cut a hole (see page 4 for a template) and install an electrical
box or mud ring/mounting bracket. Cable clamps should be
used to hold the cables in place for strain relief.
b) Trim back and/or insulate exposed cable shields with heat
shrink to reduce the chance of short circuits.
Step 3
Connect the terminated output cables to the wall plate’s rear panel
connectors, captive screw connectors, or BNC pigtails, in the correct
sequence.
• Buffered computer audio input from a 3.5 mm stereo mini plug is
output on a captive screw connector. (See the diagram below).
• Buffered stereo audio input from two RCA connectors is output to
captive screw connectors (WPB 107B only).
(See the diagram below).
WPB 103B
and
WPB 107B
Top View
3.5 mm Connector
Balanced
Stereo Output Wiring
RCA Connectors
Unbalanced
Stereo Output Wiring
12
VDC
0.1 A
WPB 107B
Bottom View
Right, tip, +
Left, tip, +
Ground, sleeve(s),
Left, ring, –
Left, tip, +
See caution.
Right, ring, –
Ground, sleeve(s),
See caution.
Right, tip, +
12
VDC
0.1 A
C For unbalanced output, connect the sleeve to ground
(Gnd). Connecting the sleeve to a negative terminal will
damage the audio output circuits.
Quick Start Guide — WPB 103B and WPB 107B
2
WPB 103B and 107B • Quick Start Guide
3
• Computer-video input on 15-pin HD connectors is output on five
female BNC connectors.
• Composite video input on a female RCA connector is output on a
female BNC connector (WPB 107B only).
Step 4
Temporarily attach the input cables to the front panel connectors.
Step 5
Verify that you have correctly wired the connectors and attached
the cables, and then test the system: connect the input and output
devices to a power source, turn them on, and check for the correct
audio/video output.
C
O
M
P
U
T
E
R
R
L
S
-
V
I
D
E
O
W
P
B
1
0
7
B
C
O
M
P
U
T
E
R
A
U
D
IO
I
N
L
R
V
I
D
E
O
Laptop
Output Device
Video Camera
Extron
WPB 107B
VGA & Audio,
S-video w/ Audio
Wall Plate
Application example showing the WPB 107B
Step 6
Disconnect all the devices from the power source, and correct any
cabling errors.
Step 7
Mount the wall plate to the wall or furniture. Being careful not to
damage the cables, place the wall plate onto or against the wall or
furniture and secure it with the supplied screws.
Step 8
Reconnect the input cables to the front panel connectors.
N For full installation details, including a full size cut-out,
consult the WPB 103B and WPB 107B Installation Manual
online at www.extron.com.