User guide

VoiceLift System with PVS 405D • Installing the Receiver (Overview) 38
Stage 3: Installing the PoleVault Switcher
See the instructions in the PoleVault Systems Featuring the PVS 405D Switcher
Installation Guide, available at www.extron.com, to install the switcher.
Stage 4: Connecting the Cables
1. Set the Mix DIP switch on the receiver dome to Off and the Tone DIP switch to On.
2. Pull the STP cable, and any other cables that will be attached, to the receiver location.
3. Terminate the STP cable with an RJ-45 plug and connect it to the RJ-45 jack labeled
Out on the receiver base (see Receiver Dome and Base Plate on page 20).
4. Connect cables for any additional devices to the receiver (for example, an MLC cable
to the Rly port, a secondary receiver to the RJ-45 In jack, and so on, see page 20).
5. Align the arrow on the dome tab with the arrow on the edge of the housing and attach
the dome to the receiver (see Removing and Replacing the Receiver Dome on
page 23).
6. Pull the cables from the receiver to the PoleVault switcher location.
7. Connect the other end of the STP cable to the PoleVault switcher (for the VLR 102) or
to the RJ-45 In jack (for the VLR 102SR secondary receiver).
Stage 5: Setting Up the Microphone and Testing the System
1. Configure the PoleVault system (see the PoleVault Systems Featuring the PVS 405D
Switcher Installation Guide).
2. Set up the microphone (set the channels, apply the label, insert the battery, and
attach the lanyard).
3. Test the system: power on all devices and test the microphone audio.