User guide

VoiceLift System with PVS 405D • Features and Operation 16
Using the wall charger — VLH 102 only
An alternative method of charging the handheld microphone is to plug the provided
wall charger into a 110-130 VAC (U.S.) or XX-240 VAC (international) power outlet, and
connect its cable to the microphone Charge jack as shown in figure 14. Charge until the
Pwr LED lights green (this takes up to 5 hours).
W
all Charger
VLH 102
Power LED
Figure 14. Connecting the Wall Charger to the Handheld Microphone
Setting Up and Using the Microphones
Follow these steps to set up the VLP 202 Pendant Microphone or the VLH 102 Handheld
Microphone and use it in a classroom:
1. Set the channels on the teacher and student (if applicable) microphones, using the
rotary switch (located on the back of the VLP 202 below the product label and behind
the battery cover of the VLH 102). Channels A and C are at 2.3 MHz, and channels B
and D are at 2.8 MHz. (The VLH 102 has only channels A and B.)
NOTE: Each microphone in the system must be set to a different frequency. For
example, on the pendant microphone A and B, A and D, B and C, or C and D
can be used together.
If the students will use a pendant microphone, it is recommended that the
channel be set to C or D. On these channels, the Volume button is disabled to
prevent inadvertent volume resets.
2. Apply the appropriate label sticker to the microphone. For example, if
your microphones have been set to channels A and B, place the Mic 1
(red) label on the microphone that is using channel A. Place the Mic 2
label (green) on the microphone using channel B.
NOTE: A recessed space is provided on the back of the pendant
microphone, below the channel adjustment switch. No location
is specified for the handheld microphone.
3. Verify that the battery is installed (see Installing or Replacing the Microphone
Battery on page 13) and charged (see Charging the Microphone Battery on
page 14).
33-1694-01 A 08 08
Teacher
Mic 1
Student
Mic 2