Operating instructions

2-9

VoiceLift

™

Microphone • Operation and Features

PRELIMINARY

Sleeve ( )

Ring (

)

Tip (+)

3.5 mm Stereo Plug Connector

(balanced)

Setting up the VLP 102 Pendant Microphone

Follow these steps to set up the VLP 102 pendant microphone and use it in a

classroom:

1. Set the channels on the teacher and student (if applicable) microphones, using

the rotary switch located on the back of the microphone below the product

label. Channels A and C are at 2.3 MHz; channels B and D are at 2.8 MHz.

Each microphone must be set to a different frequency; in other words, A and B, A

and D, B and C, or C and D can be used together.

It is recommended that the microphone that the students will use be set to

channel C or D. On these channels, the Volume button is disabled, and the

student is not able to inadvertently reset the volume.

2. Apply the appropriate label sticker (part #33-1694-01) to the

space provided on the back of the microphone (below the

channel adjustment switch).

For example, if your microphones have been set to channels

A and D, place the Teacher (red) label on the microphone

that is using channel A; place the Student label (green) on the

microphone using channel D.

3. Slide the battery door downward to remove it (see the illustration at left).

4. Insert the AA battery and charge it, if necessary, by placing the microphone

in the VLC 102 charging station or by connecting the wall charger to the

microphone’s Charge jack. (See “Charging the microphone,” earlier in this

chapter.)

5. When the microphone is fully charged (the Pwr LED on top lights green),

remove it from the charging station, or disconnect it from the wall charger.

VLC 102 Charging Station

Wall Charger

33-1694-01 A 08 08

Teacher

Mic 1

Student

Mic 2