Installation guide
© 2009 Extron Electronics. All rights reserved.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.15 68
+86.21.3760.15 66 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
Outline of installation steps
Stage 1 — Install the VLR 102 Receiver
Drop ceiling:
c Cut a hole in the ceiling tile. (page 2-4)
c Mount the receiver housing to the ceiling tile. (page 2-4)
c Attach a conduit to the back plate if needed. (page 2-5)
Junction box:
c Install the junction box. (page 2-6)
c Attach the receiver housing to the junction box. (page 2-6)
c Attach a conduit to the junction box if needed. (page 2-6)
Wall or other hard surface:
c Install a raceway if needed. (page 2-7)
c Mark the mounting screw locations on the surface. (page 2-7)
c If using a raceway, remove the appropriate knockout in the
receiver housing. (page 2-7)
c Mount the receiver housing to the surface. (page 2-8)
Stage 2 — Connect the Receiver to the PoleVault System
c Pull the cables to the receiver. (page 2-10)
c Connect the cables to the receiver. (page 2-10)
c Attach the receiver dome to the housing. (page 2-11)
c Pull cables to the PoleVault switcher. (page 2-13)
Stage 3 — Configure and Test the System
c Congure the system. (page 2-14)
c Set up the microphone (page 2-14)
c Test the system. (page 2-14)
c Complete the installation. (page 2-15)