Installation guide
Installing the Receiver in a Wall or Other Hard Surface
1. Install a raceway if needed.
If using a raceway for the cables, install it at the appropriate
location on the mounting surface.
N
Racewayknockoutsonthereceiverhousingt
common types of raceways such as the Wiremold
500/700 series and the Wiremold 2400 series.
2. Mark the mounting screw locations on
the surface.
Use the receiver housing to mark the screw locations on the
mounting surface.
3. If using a raceway, remove the
appropriate knockout in the receiver
housing.
a. Use a knife to score around the edge of the selected
knockout to create a clean edge.
b. Press on the scored section to remove it.
b
Mark mounting screw locations in the
surface.
a
Install the raceway (if needed).
c
Remove a raceway knockout from the
housing, if needed.
Raceway
Knockouts (2)
2-7
VoiceLift Microphone Installation • Installation — Stage 1