User guide

VNR 100 • Replacing the VNR 100 Drives 16
4. Swing the lever arm out until
it is perpendicular to the front
of the drive caddy (as shown
in the figure to the right). Use
the arm to pull the caddy out
of the drive bay.
5. Remove the drive. There are
no screws to be removed
or cable connections to be
undone.
6. Insert the new drive into the drive bay.
7. Push the caddy back into the recorder.
8. Swing the lever arm back until it clicks into place behind the catch.
ATTENTION: Do not power on the unit at this time.
Configuring the New Drive
1. Attach a mouse to the rear panel PS/2 mouse port (
e
)
and a keyboard to the rear panel PS/2 keyboard port
(
f
). Alternatively, you may connect the mouse and
keyboard to the front panel USB ports (
c
in the figure
on page 15) or the rear panel USB ports (
d
).
2. Connect a VGA monitor to the rear panel port (
g
).
3. Power on the recorder by pressing the front panel power
switch (
a
in figure 14 on page 15).
4. Power on the monitor. The login screen
is displayed.
5. Enter the Username and Password.
NOTE: By default, the Username is
matrix_rec and the Password is
matrix.
6. From the menu bar on the desktop, select
Applications > Internet > Firefox Web
Browser
.
e
f
d
d
g