User Guide Owner's manual

Section 1: Installation & Setup VN-QUANTUM User Guide
Page 38 I455GB issue 8
Installing VN-COMMANDER Software
IMPORTANT NOTE: VN-QUANTUM requires VN-COMMANDER v1.4 software. No other version
of VN-COMMANDER or CT-COMMANDER will work with VN-QUANTUM.
The VN-QUANTUM CONNECT processor requires VN-COMMANDER
CONNECT control software. No other version of VN-COMMANDER will work
with the VN-QUANTUM CONNECT processor.
Computer Specification
The VN-COMMANDER application software must be installed on a computer that meets or exceeds
the following specification:
Minimum Recommended
Operating System
Windows NT4 (SP6) Windows 2000, XP
Processor Speed
200MHz 450MHz or higher
Memory (RAM)
64MB 128MB or higher
Hard Disk Free Space
30MB >30MB
Graphics
1024x768, 65K colors (16-bit) 1024x768, 16.7M colors (32-bit)
Network Card (Ethernet)
10BASE-T 100BASE-T
Installation Procedure
The VN-COMMANDER application software is provided on the VN-QUANTUM System Disc.
 Insert the VN-QUANTUM System Disc into a CD-ROM drive on the computer. After a few
seconds the disc browser should start automatically.
HINT: If the disc browser does not start for any reason, start it manually by running the setup.exe
file located on the root of the disc.
 Click on the Install VN-COMMANDER option then follow the on-screen instructions.