User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
Section 5: Serial Transport & Control Methods VN-MATRIX User Guide
Page 92 I458GB issue 6
Setting-up a Remote Control Group
Decide which VN-MATRIX unit(s) will act as the remote control client(s) and connect your serial
control device(s) to the VN-MATRIX COM2 port(s) accordingly.
Login to the Web Interface (see page 41).
From the Device List page click on the device you want to configure as a remote control client.
From the Device page click the Serial tab to display the following:
Using the mode listbox select the client option.
Using the destination listbox select the remote-control option.
Change the other settings (e.g. baud rate) as required, then click the Save tab.