User Guide User guide
Table Of Contents
- What is VN-MATRIX?
- Functional Overview
- Example System Application
- Front Panel Features
- Rear Panel Features
- Accessories
- Choosing a Suitable Location
- Mains Power Connection (via PSU)
- Mains Power Cord (for PSU)
- Setup and Connection Procedure
- The VN-MATRIX Web Interface
- Configuring a VN-MATRIX as an Encoder (source)
- Configuring a VN-MATRIX as a Decoder (display)
- Troubleshooting
- Encoder Set Up
- Decoder Set Up
- System Set Up
- Overview
- Setting-up a Serial Data Stream
- Setting-up a Serial Passthrough Group
- Setting-up a Remote Control Group
- Serial / Telnet Commands
- Overview
- VN-MATRIX Hardware
- Serial Interface – Quick Reference
- Telnet Interface – Quick Reference
- Web Interface – Quick Reference
- Network Characteristics
VN-MATRIX User Guide Section 4: Advanced Setup Procedures
I458GB issue 6 Page 83
To upload the firmware file to the VN-MATRIX controller…
Login to the Web Interface (see page 41).
From the Device List page click on the VN-MATRIX controller device.
From the Device page click the Upgrade tab. The Upgrade page will appear:
Click the Browse button to navigate to the required upgrade file, or type the path and filename
directly into the field provided.
Click the Upload button to begin uploading the file to the VN-MATRIX controller. This may take a
few minutes.
Once the file is uploaded, you can begin installing it into each unit (as described on page 84)
starting with the controller unit.
This is the existing firmware version.
This is the version you will be upgrading to.